Show all

Extend HD AV and Ethernet

Product model: EMT-E100E

Categories: ,

Introduction

The Extender is based on the HDBaseT technology. It extends your HD display with the resolutions

of 1080p/60Hz up to 330 feet (100 meters) away from your HDMI or DVI-D source using one CAT5e/6 cable.

It also extends Ethernet and provides an IR back channel to control AV sources using the same CAT5e/6 cable.

The three Ethernet ports on both the Sender and Receiver are connected to standard network devices such as

100Base-T routers and hubs. Built-in IR extender function allows IR remote control of Source devices from remote

viewing location by sending IR commands received in the vicinity of the Display back to the Source devices.

 

Features

Support HDCP

Support uncompressed HDMI signal.

Enables HDMI10.2 Gbps and 100Mbps Ethernet in parallel over a single 100mCat5e/6 cable.

Support 340MHz/3.4Gbps per channel (10.2Gbps all channel) bandwidth.

Support 1080p@60Hz@48bit pixels

Support 3D pass-through.

Support CEC pass-through.

Support uncompressed audio

Support compressed audio

There are 3 standard Ethernet ports with switching capabilities on each unit. There is no difference 

between the 3 and any type of connection topology is permitted.

Built-in IR extender function allows IR remote control of Source devices from remote viewing location 

by sending IR commands received in the vicinity of the Display back to the Source devices.

CAT5e/6 cable follows the standard of IEEE-568B.

 

AV/USB Extender
Support HDMI10.2 Gbps and 100Mbps Ethernet in parallel over a single 100mCat5e/6 cable
Support 340MHz/3.4Gbps per channel (10.2Gbps all channel) bandwidth
Support 1080p@60Hz@48bit pixels
Support 3D pass-through
Support CEC pass-through